Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 05/29/2021 in all areas

  1. Thanks for the pictures Bill
    1 point
  2. Have a look for an unused 3 pin connector near the other gearbox wiring connectors that matches the Ford speedo transducer. It's usually got a plastic plug in it for protection & is taped to the rest of the loom.
    1 point
  3. You are gonna cook your setup running 0 degrees of timing, don't do that. On E85 at 17psi you'll find your max power is close to 18 degrees of timing but you need to verify it on the dyno. I run 18.5 degrees on E85 making a touch over 700awkw at 31psi. This is a built motor obviously. Don't go crazy with timing, you can't just add more to make more power, it doesn't work like that. It'll stop making power before it knocks but it will stress the motor a lot more if you keep adding timing. It'll chuck the rods out if you go there. Maybe go back to 12psi and start from there, as it'll pull a lot harder than it is now with the correct timing in it.
    1 point
×
×
  • Create New...