2kclay

sorry i think you may have missed it im using a tactrix openport clone from ebay that ive used previously with no fault.

not when clearing the dtc's with forscan. when i try to get any info from the car into pcmtec the same error message shows up. i checked dtc's again and the p2105 showed up cleared it, restarted forscan and no p2105.

pcmtec still doesnt work. same error. checked the dtc's in forscan and the p2105 code showed up.

so i tried exactly what you said and i only have 2 codes now. the restraint module is correct as my clockspring has had it. i havent tried pcmtec yet this looks better.txt

i use a clone from ebay. this is my second one as the first one burnt out but i havent had an issue using it with pcmtec before. ill give what you suggested a try now and ill get back to you in about 20 min

right im at a loss with this thing. ive been trying different things all morning. tried recovery mode with pcmtec and still get the same error code. ive cleared my dtc's with forscan and ive also gone into module calibration for pats and also reset the tcm, hem,bcm. i cant reset the pcm tho it says service procedure not supported. find attached a dtc log file. now all of codes have always been on my car from when i bought it 2 years ago and i havent had an issue with aything. when i try to connect pcmtec to the car it enables the immobilser as the car wont crank unless i ignition cycle. battery has 12.5 volts as well and forscan doesnt have an issue. fuck this car sometimes.txt

g'day everyone, recently upgraded a laptop and im trying to connect to my car after a few months of no connection to the pcm via obd. ive fired up pcmtec plugged the cable in and tried to read the vehicle information. The ignition cycles but i get an error message saying SECURITY_ACCESS Recieved: SERVICE_NOT_SUPPORTED. I've than connected with forscan and done a dtc clear as i had some dtc's and noticed it says p1000 code for obd readiness and one ive never seen before flashing with pmctec p2105 code. since ive last connected to pcmtec ive gone through a motor and im now running a green top over the silver bf na. same pcm and tcm. any help much appreciated thanks!

Sorry I just realised I made a few spelling mistakes in that. It was'nt doing it before the motor swap. I shall try another set of coils and plugs and see if its any different. Cheers

Hey Guys, Currently chasing an issue with my car. I have an na+t but got a bluetooth rod in cylinder 6 last week and have since put a bf gas motor in retaining all the na accessories. (It was just a gas long block). Since doing so everytime the car sees around 5 psi the abs light flashes the transmission slips and the speedo stops working and doesnt recovery unless cycling the car. It was doing before and the na motor was seeing up to 15 psi (averaged 12) and was doing absolutely fine until rod went spacex. While I had the motor out i took the opertunity to install an external trans cooler. Box is na zf. Spec List of car: Pulsar gtx3584rs gen 2 gfb ex44 (5psi spring) e85. walbro 460 pump. turbo fuel reg. no forward 02 sensor as i have an aftermarket wideband installed Turbosmart eboost 2 for boost control. retains na map sensor. Cheers for any help.

Hi, I've been looking into purchasing pcmtec and im wondering if im able to use my sct x3 flash tuner to flash the tune files onto the pcm without the need for a laptop. I have a desktop computer and an sct x3 flash tuner thats unmarried. Thanks. Clayton