overlap

How did you get on?

FG MK2 NA , Can Turbo strategy be written to the NA Pcm?

If it is possible there must be more to it? . If no pcm is detected the "trans" button is not selectable in the logger.

In this case im Running a haltech pcm but still use pcmtec to tune the tcm. Assuming I need a ford pcm for the trans data to be logged successfully . Thanks .

Has anyone successfully logged the ZF transmission live data with PCMTec when using an aftermarket PCM ? Reading and writing to the TCM etc works as per normal but really need the live data. Cheers

Did you manage to sort this? Id like to increase tcc apply pressure also.

Transplanted FG Running gear into foreign chassis. Engine runs fine but we keep getting P0659 & trans always in Limp Mode. Im using an FG shifter, terminating resistor at the trans plug , have 60ohms on the canbus.

Cheers Bill, Just waiting for the Ford forum approval!

@Roland@pcmtec , is there a canbus network available to us in document form for diagnostic purposes? Mk2 G6E

Found it 👍

Which part of the open loop procedure causes applied dc to the solenoid at idle and stalled?

would that be wastegate failed closed? or a combination ? thanks

Can we still effectively run an over boost shutdown in open loop boost control ?

I have a boosted ba xr8 , cold start great , have it performing well etc everywhere alse , only challenge left is hot start.. to fire during a hot start it Needs WOT to fire, assuming its getting too much cranking enrichment, as idle is very rich for around 10 seconds before the inj pw halves and runs great at target afr. Where would I start looking for the over commanded fueling at crank during operating temp. Thanks BAXR8 boosted tune file_CustomOS.tec

they are an awesome trans! just been upping my pressures and upshift pressures today, haltech pcm but love the control with pcmtec for trans tuning.