Xr6t3984

i have a na ute with a turbo ba motor i want it to run 7 pounds of boost but it seems to just want to climb more and more above 11psi i just looked at my desired boost setting and it says it wants 16psi on all rev's? im running the stock n/a strategy with some changes to support the engine swap il upload here also HAANGK2 turbo changes.tec

I also had this problem when I was trying to get technical support

well that was a waste of 2 credits hahaha, can i just copy over the main files from HAAS4Y4 strategy to my stock n/a tune to get it running decently for now?

i should add that the ute is n/a ute but i have installed a factory turbo engine out of a 2003 ba ute i will add the factory tune of the n/a ute HAANGK2.tec

i have flashed a tune into my ba xr6 ute and the btr seems to be stuck in 3rd, wont let me change gears with sports shift it does not come up on the dash, not too sure what has gone wrong,i have attached the file im working with. it works fine when i flash the stock tune filr back in HAAS4Y4 5.tec

By “playing around” I mean I am slowly learning with a friend. I’m also wondering if anyone has a stock ba xr6 turbo Ute tune as I don’t have access to the Ute Ecu the motor came from, apparently it would be easier to start with the factory tune and go from there? I’d even be willing to pay for a basic tune so I don’t hurt my engine while I’m learning so I have a reference point to start from

I have put a turbo ba motor into my n/a xr6 Ba Ute what is some things I should know before I start playing around with the tuning capabilities so I don’t Grenade the engine it runs but it splutters a bit at idle and Its running super rich eating fuel I’m going to buy a gfb electric boost controller cause I have been told the stock ba ecu’s Cannot control the boost with the solenoid and I have installed a turbo map sensor