Jake

Forgot to add, still using the NA loom. Jake.

That's correct. Having issues now with P2110-40 and P0701-20 Goes into limp mode and check engine. Anyone got any ideas, have I missed something. Thanks, Jake. HAEK2NE - TURBO PCM SWAP - 1000cc - 3bar MAP - OL BOOST - NO BOOST SENSOR - NO OIL TEMP - R6.tec

Couldn’t find you on Facebook/messenger. this is that green one again.

I’m working with an FG mk2 xr6 NA auto, the customer has swapped in a turbo zf trans, gas motor and fitted a turbo. 1st issue - throttle body actuator dtc and limp mode on gear kickdown. Other than that seems to work fine. 2nd - we fitted a turbo pcm but cannot perform pats reset. Not supported on oil anyone completed a mk2 Fg pcm swap or na to turbo conversion shine any lights? thanks. jake.

I was afraid that might be the case, they have already assembled everything and dropped it off. I’ll have to have a chat and see what they want to do. thanks again for the help.

Hey all, I’ve got a fgmk2 na xr6 retaining the na pcm where they have : fitted a turbo swapped in a turbo zf trans and it’s got a gas bottom end. is there a way to get this trans to work with this pcm? pcm HAEK2AE tcm 8R29-7J105-EG pcm desired cal level is 12 tcm cal level is 4 thanks.

That’s what I thought they did. Thanks Roland.

Hey guys, Ive got a miami brand new PCM with NO VIN programmed. Trying to run it as a standalone, just checking, with PATS disabled will it bypass the VIN check? We are getting no fuel pump prime and obviously no fire, but also no comms through the vehicle OBD port. its fine on the bench. Put it in my f6 to check and we have comms but no prime. does this point to wiring? or does it need a VIN? File attached Thanks in advance. Jake. HAFJ2Y2 - GT40 - BASE - PATS OFF x 3 - R1.tec

I’ve got a BA already using custom OS, is there a way to add the full vct control to this without licensing the full 7 credits again? thanks jake.

Sign me up!! thanks.

No dramas, I’m a little way of having all my instrumentation finished (need isolation cash😉)so 8 will do for a bit. thanks, jake.

I will find out tomorrow

Is it possible to use the 20 Chanel version? https://www.digikey.com.au/product-detail/en/dlp-design-inc/DLP-IO20/813-1027-ND/2135093 Is there a limit in the software as to how many aux analog channels can be logged? thanks jake.