[DATA LOGGER]

5 hours ago, Roland@pcmtec said:

Great. How are you finding the equation editor, does it let you set up the correct scaling easily?

I have only used it for a few devices and they have all been a basic linear translation, the equation editor has been easy to setup for them.

[DATA LOGGER]

1 hour ago, DanStraffa said:

Okay awesome thank you.

What gauge are you using ?

Am using the innovate mtx-l

1 hour ago, finnigan001 said:

I’m doing the same.  However, not even running a ground to it as the gauge already grounds elsewhere. Using the 5v output from my Innovate ECF-1 which I’ve wired up for E85 to the rear o2 sensor as well.

Have not had any issues with logging the wideband at all. 

 

I am only using the same ground as the guage as it was giving me a more accurate and consistent reading.

[DATA LOGGER]

2 minutes ago, DanStraffa said:

How did you wire yours up?

I am just running the 0-5v output to input 1 and the guage ground to the gnd input

[DATA LOGGER]

I have been using one to log my wideband for a while, seems to to be working fine with no issues sofar

[Editing previously licenced Files]

Hey,

If i read a PCM that has been previously licensed by someone else, can it be edited/written using my account or would it need to be re-licenced under my account? 

thanks

[DATA LOGGER]

Hey Roland, can you send me a copy of the logger. thanks

[Turbo tune onto NA PCM]

Sounds like the compare is the way to go, thanks for the info

[Turbo tune onto NA PCM]

Awsome, so it should be a simple as merging the base turbo tune with the one currently on the pcm?

[Turbo tune onto NA PCM]

Is it possible to flash a turbo tune onto a na pcm?

Would obviously have to disable the boost control as the na pcm dosnt have the required hardware to drive the solenoid.