[PCMTEC Editor Version 0.72 Release Notes]

When are you expecting the data logger to be released ??. It's abit hard to data Log with the innovative lm2 lol. 

[HOWTO: Injector Scaling Basics]

Is it normal for the stft to go to + 40% AT WOT even with cloced loop disabled or am I doing somthing. 

[DATA LOGGER]

How duse one deturmin where you are in the load. Say 1.3 load at 4500 rpm.? I can't fined this load function in forscan or in my innovative lm2 datalogger. 

[Flex Fuel/Dual Map Discussion]

I'm keen to give it a go !!

[HOWTO: Ghost Cam and VCT simplification]

We where playing around. I think it was about 30 to 35. 

[HOWTO: Ghost Cam and VCT simplification]

Mate and I giving it a go 

[Licensing]

Ok thank you send it off tonight. 

Cheers 

[Licensing]

It is a engine conversion so the Pat's where turned off. It seams to have a failed injector drive. 

[Licensing]

Hi 

I have a faulty pcm that is licensed is there anyway I can unlicensed the original pcm and relicense the new PCM?

[HOWTO: Injector Scaling Basics]

At idle its afr is 11.0 with the 02 disconnected as soon as you hit the throttle it pops and farts and afrs got to like 20.7. Like a big lean spot 

[HOWTO: Injector Scaling Basics]

Iam not a 100% sure if the data sheet is correct for the injectors thay are bosch 160lb white tops p/n 02080150846 thay are matched. Its running 2 bosch 044 fuel pumps a trubo smart fpr1200 reg set to 40psi. 

[HOWTO: Injector Scaling Basics]

Hi i have a set of bosch 160lb injectors and am having problems scaling them. i can get them to ldle but as soon as you touch the throttle it pops and bangs and goes lean i have tried to move the breakpoint and pw around with no luck am I missing somthing. Ps I have attached the data sheet of the injectors.

[4bar map install]

Hi

I am installing a 4 bar map senser.I am unsure on what parameters need to be adjusted to make it work could you please point me in the correct location. Also on a ba computer is there a way to add more load cells to change the load points on the timing tables or is this all I can do.

[User Guide: First time setup of the Editor and vehicle read]

Hi

If the ecu was lianced and tuned with pcmtec then i bye pcmtec for myself is it going to cost me a licence to tune it for my self 

[Fuel tables]

Ok so the RPM / TPS table is used for a full WOT run at 20 psi of boost to or is there a load tabel for this.

[Fuel tables]

What tables are the main fueling tables to adjust afr ratio for rpm load. The only table i can see is the rpm / tps table and the rest of the tables seam to be for heat related.