overlap
Members-
Posts
21 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Everything posted by overlap
-
How did you get on?
-
If it is possible there must be more to it? . If no pcm is detected the "trans" button is not selectable in the logger.
-
In this case im Running a haltech pcm but still use pcmtec to tune the tcm. Assuming I need a ford pcm for the trans data to be logged successfully . Thanks .
-
Has anyone successfully logged the ZF transmission live data with PCMTec when using an aftermarket PCM ? Reading and writing to the TCM etc works as per normal but really need the live data. Cheers
-
Did you manage to sort this? Id like to increase tcc apply pressure also.
-
Transplanted FG Running gear into foreign chassis. Engine runs fine but we keep getting P0659 & trans always in Limp Mode. Im using an FG shifter, terminating resistor at the trans plug , have 60ohms on the canbus.
-
HOWTO: FG ZF6 to Manual conversion CAN bus wiring issues
overlap replied to Roland@pcmtec's topic in Falcon HOWTO Guides
Cheers Bill, Just waiting for the Ford forum approval! -
HOWTO: FG ZF6 to Manual conversion CAN bus wiring issues
overlap replied to Roland@pcmtec's topic in Falcon HOWTO Guides
@Roland@pcmtec , is there a canbus network available to us in document form for diagnostic purposes? Mk2 G6E -
Found it 👍
-
Which part of the open loop procedure causes applied dc to the solenoid at idle and stalled?
-
would that be wastegate failed closed? or a combination ? thanks
-
Can we still effectively run an over boost shutdown in open loop boost control ?
-
I have a boosted ba xr8 , cold start great , have it performing well etc everywhere alse , only challenge left is hot start.. to fire during a hot start it Needs WOT to fire, assuming its getting too much cranking enrichment, as idle is very rich for around 10 seconds before the inj pw halves and runs great at target afr. Where would I start looking for the over commanded fueling at crank during operating temp. Thanks BAXR8 boosted tune file_CustomOS.tec
-
they are an awesome trans! just been upping my pressures and upshift pressures today, haltech pcm but love the control with pcmtec for trans tuning.
-
Hi beerturbo, I have a built trans (ZF) ive also modified the stator for a looser convertor , laggyish turbo too (g35/1050) , i just find it drives around the street so much smoother without the tcc.. However im all about it in 5&6th cruising. Cheers
-
Hi there, TCC lock up points, Ideally only have it active/locked in 5/6th cruising.
-
Can we control the TCC through the zf trans maps? Thanks
-
Evening guys. If I had carried out the above open FG loop procedure but had left some small numbers in the "boost integral gain" auF0286 , would this be why im seeing 5-10% duty cycle even with zero DC in the auF16463 wastegate duty cycle table? Im yet to get a chance to test it. Cheers
-
Hi Roland, Has there been an FG How too boost control guide written up yet? Thanks
-
HOWTO: Ghost Cam and VCT simplification
overlap replied to Roland@pcmtec's topic in Falcon HOWTO Guides
Hi Roland, How do I add the auF0164 parameter to just my Ghost cam tune? Thanks