boostedfalcon

Any more info on this? Chasing info on what should be done when fitting fg coils to a BA. Does anyone have the dwell setting to be used for this please?

Thanks.. Tec file sent

Is TPS > auF100016 applicable with a ba falcon setting up flat shift ? It will not come up whilst setting up everything it the custom operating system. everything else seems to be there. Or do i just follow the “bf manual launch control / flat shift” guide? Thanks in advance.

Hi Roland If i set the value over 3sec on auf100033 with the cruise control button on i have no speedo, also if the cruise is off and speedo working fine if i pull the cruise trigger to activate launch control the speedo drops out until i release the trigger then the speedo cones back fine, works fine if the value is not over the 3sec. Any ideas ?

Looking at options utilising multitune boost by gear or boost by speed, ba falcon current setup 50mm external gate with a 15lb spring using a 3 port mac switch, tr6060 manual cars making 428kw on low boost 522kw high boost 22lb looking to move to a smaller spring ie 7lb and utilising a 4 port mac switch to try get some sort of usability on the street. But i dont want to loose and control on the high boost. Whats everyones thoughts? I have workshop level software. Have many people had success similar setups? Thanks in advance..

Thanks Roland

i had a similar issue, i found in the vid block i had to change speed control to enabled from unconfigured speed control type to basic intergrated from unconfigured problem sorted

replaced pcm to resolve issue, pcm would not recognise voltage input to C2

auF100034 to a setting higher than 3 seconds. This could be used if you are running dual fuels and need to idle the engine for several seconds at the petrol station to purge fuel (not recommended for most use cases). is there an issue to set auF100034 for extended time so ya dont have to turn the car off to change tunes?

thanks Bill ABS only, will need the speed source set to ABS via wire (this sorted it) very much appreciated

any feedback on the fix for this one? i have the same issue, fitted a turbo pcm to my n/a ba xr6 with abs but without traction control. no abs faults but i cannot get the speedo to work.

@Roland@pcmtec i have attached a screen shot of key on engine off, 1.10v going into Pin C2, i dont seem to have any issues with boost the control side of things only with recognising the boost pressure sensor.

Thanks mate, ok great to hear.. i will have a look forther into it later today. very much appreciated

I peeled back the sticker and the ABU is ABU-243

Hi Roland, the part number is 3R23-12A650-ACD

Hey fellas ba falcon na+t utilising a ba LPG pcm with a HAAT3VC strategy to utilise factory boost control. I have wired the boost pressure switch and the mac switch directly to the c plug and b plug using a 3bar tmap and a 4 bar bps from ims Wired up as per below c2 boost signal c30 5v c21 turbo smart 3 port mac switch b33 signal ground i have 1.10v returning out of the boost pressure switch engine off key on, i am getting a P0237 DTC (turbo boost sensor a circuit low) i have 5v to the sensor , checked continuity from the plug on the sensor back to C2 and all is fine. Anything im missing or a setting i need to change. thanks in advance

hey guys experiencing an issue licencing a ba falcon its saying the .dat file is missing and still showing as unlicensed but has used credits. thanks or any help. first time pcm tec user