Lag6 Posted April 13, 2020 Share Posted April 13, 2020 So i have a na barra with a turbo in a patrol, and all is working well, in relation to starting and driving etc. turbo logic turned on, a couple system switches changed and maps copied over and it all loves it so far. The one thing that has me though is the thermo fans. after the 5sec delay they turn on full, and stay on.. now I think this could be because I do not have a vehicle speed source set up yet. but surely there is a setting where I can remove all the things in relation to that and go off of ECT? Also wondering what auF3177 - PCM generated vspd source. 1: OSS & TCSS_ 2: OSS over CAN_ 3: VSS hardware_ 4: f Can be used for, assuming it is for vehicle speed source, but unsure what the abbreviations are in settings 1, 2, 3 and 4, if anyone could learn me that would be sweet! I am hoping something in there will work with VSS_Source and the drop down tab. which also has abbreviations - VRS via wire and MR via wire. Could anyone please learn me on VRS and MR too?? Thanks Legends! any questions about the conversion and whatever else you might want to know feel free to ask! all here to help out! Quote Link to comment Share on other sites More sharing options...
BarraDrifter Posted April 17, 2020 Share Posted April 17, 2020 Have you got the pressure switch for the A/C plugged in? Might sound silly but it can cause the fans to run flat out strait away and not turn off. It doesn't have to be plumbed into the A/C system just plugged into the connector to make it work as it should. Quote Link to comment Share on other sites More sharing options...
Roland@pcmtec Posted April 20, 2020 Share Posted April 20, 2020 Enable the VID block and use the speed source drop down in the VID Block section, auF3177 is not what you want in most cases. If this is a BA/BF you can select output shaft sensor and wire in a hall effect sensor for speed. FG does not have a speed input and can only have speed via canbus from either the ABS module or a ZF Transmission. If its an FG you can speak to CANBarra who make a module which should be able to emulate the speed. https://www.facebook.com/CANBarra/ Quote Link to comment Share on other sites More sharing options...
Roland@pcmtec Posted April 20, 2020 Share Posted April 20, 2020 The numbers for auF3177 for reference are as follows. This is only for the BTR I believe. 1 OSS or TCSS used 2 OSS to ECM over CAN 3 VSS hardware. 4 ABS through hard wire. 5 ABS over CAN. Quote Link to comment Share on other sites More sharing options...
Lag6 Posted April 21, 2020 Author Share Posted April 21, 2020 Thanks all for the responses. Love that this is all available. Yes it has the factory aircon switch, plugged in and working. So that is not the cause this time, great thought though! Thanks Roland, appreciate the input as always! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.