Carl

When are you expecting the data logger to be released ??. It's abit hard to data Log with the innovative lm2 lol.

Is it normal for the stft to go to + 40% AT WOT even with cloced loop disabled or am I doing somthing.

How duse one deturmin where you are in the load. Say 1.3 load at 4500 rpm.? I can't fined this load function in forscan or in my innovative lm2 datalogger.

I'm keen to give it a go !!

We where playing around. I think it was about 30 to 35.

Mate and I giving it a go received_10215041226331801.mp4 20180803_073340.mp4

Ok thank you send it off tonight. Cheers

It is a engine conversion so the Pat's where turned off. It seams to have a failed injector drive.

Hi I have a faulty pcm that is licensed is there anyway I can unlicensed the original pcm and relicense the new PCM?

At idle its afr is 11.0 with the 02 disconnected as soon as you hit the throttle it pops and farts and afrs got to like 20.7. Like a big lean spot

Iam not a 100% sure if the data sheet is correct for the injectors thay are bosch 160lb white tops p/n 02080150846 thay are matched. Its running 2 bosch 044 fuel pumps a trubo smart fpr1200 reg set to 40psi.

Hi i have a set of bosch 160lb injectors and am having problems scaling them. i can get them to ldle but as soon as you touch the throttle it pops and bangs and goes lean i have tried to move the breakpoint and pw around with no luck am I missing somthing. Ps I have attached the data sheet of the injectors.

Hi I am installing a 4 bar map senser.I am unsure on what parameters need to be adjusted to make it work could you please point me in the correct location. Also on a ba computer is there a way to add more load cells to change the load points on the timing tables or is this all I can do.

Hi If the ecu was lianced and tuned with pcmtec then i bye pcmtec for myself is it going to cost me a licence to tune it for my self

Ok so the RPM / TPS table is used for a full WOT run at 20 psi of boost to or is there a load tabel for this.

What tables are the main fueling tables to adjust afr ratio for rpm load. The only table i can see is the rpm / tps table and the rest of the tables seam to be for heat related.